Debug Wr-Reg - Cisco MDS 9000 series Command Reference Manual

debug wr-reg

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug wr-reg
To enable debugging for the list of devices using the write-register feature, use the debug wr-reg
command in EXEC mode. To disable a debug command, use the no form of the command or use the no
debug all command to turn off all debugging.
Syntax Description device-name
register-address
Defaults Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example displays the system output when the debug wr-reg command is issued:
switch# debug wr-reg
Related Commands Command
no debug all
Cisco MDS 9000 Family Command Reference
6-128
debug wr-reg [device-name | register-address]
no debug wr-reg [device-name | register-address]
Modification
This command was introduced.
Description
Disables all debugging.
Specifies the device name for the required device.
Specifies the register address for the required device.
Chapter 6 Debug Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x