Chapter 6
Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug rlir
To enable Registered Link Incident Report (RLIR) debugging, use the debug rlir command in EXEC
mode. To disable a debug command, use the no form of the command or use the no debug all command
to turn off all debugging.
Syntax Description
all
errors
events
mts-errors
mts-events
Defaults
Disabled.
Command Modes
EXEC mode.
Command History
Release
1.0(2)
Usage Guidelines
None.
Examples
The following example displays the system output when the debug rlir all command is issued:
switch# debug rlir all
Related Commands
Command
no debug all
show rlir
OL-8413-07, Cisco MDS SAN-OS Release 3.x
debug rlir {all | errors | events | mts-errors | mts-events}
no debug rlir {all | errors | events | mts-errors | mts-events}
Modification
This command was introduced.
Description
Disables all debugging.
Displays information about RLIR, Link Incident Record Registration
(LIRR), and Distribute Registered Link Incident Record (DRLIR) frames.
Enables debugging for all RLIR features.
Enables debugging for RLIR error conditions.
Enables debugging for the RLIR events.
Enables debugging for MTS error conditions.
Enables debugging for MTS events.
Cisco MDS 9000 Family Command Reference
debug rlir
6-101