Fspf Dead-Interval - Cisco MDS 9000 series Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fspf dead-interval

To set the maximum interval for which a hello message must be received before the neighbor is
considered lost, use the fspf dead-interval command. To revert to the default value, use the no form of
the command.
Syntax Description seconds
vsan vsan-id
Defaults 80 seconds
Command Modes
Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Access this command from the
This value must be the same in the ports at both ends of the ISL.
Note
Caution An error is reported at the command prompt if the configured dead time interval is less than the hello
time interval.
Examples The following example configures the maximum interval of 400 seconds for a hello message before the
neighbor is considered lost.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf dead-interval 4000 vsan 1
Related Commands Command
show fspf interface
show interface fcip
OL-8413-07, Cisco MDS SAN-OS Release 3.x
fspf dead-interval seconds vsan vsan-id
no fspf dead-interval seconds vsan vsan-id
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified FCIP interface.
Specifies the FSPF dead interval in seconds. The rage is 2 to 65535.
Specifies a VSAN ID. The range is 1 to 4093.
submode.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
fspf dead-interval
8-77