Policy - Cisco MDS 9000 series Command Reference Manual

policy

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
policy
To enter IKE policy configuration and configure a policy for the IKE protocol, use the policy command
in IKE configuration submode. To delete the policy, use the no form of the command.
Syntax Description
priority
Defaults None.
Command Modes
IKE configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples
The following example shows how to configure a policy priority number for the IKE protocol.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)#
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
18-12
policy priority
no policy priority
Specifies the priority for the IKE policy. The range is 1 to 255, where 1 is the
high priority and 255 is the lowest.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Chapter 18 P Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x