Sdv Abort Vsan - Cisco MDS 9000 series Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

sdv abort vsan

To terminate an SDV configuration for a specified VSAN, use the sdv abort vsan command in
configuration mode.
Syntax Description abort
vsan vsan-id
Defaults
Disabled.
Command Modes
Configuration mode.
Command History Release
3.1(2)
Usage Guidelines To use this command, you must enable SDV using the sdv enable command.
Examples
The following example shows how to terminate an SDV configuration for a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# sdv abort vsan 2
Related Commands Command
show sdv database
sdv enable
OL-8413-07, Cisco MDS SAN-OS Release 3.x
sdv abort vsan vsan-id
Terminates the SDV configuration.
Specifies the number of the VSAN. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays the SDV database.
Enables SDV.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
sdv abort vsan
21-13