Ips Netsim Qsize - Cisco MDS 9000 series Command Reference Manual

ips netsim qsize

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ips netsim qsize
To limit the size of the queue on a specified Gigabit Ethernet interface, use the ips netsim qsize
command in SAN extension tuner configuration submode.
Syntax Description qsize queue-size
ingress
gigabitethernet
slot/ port
Defaults
Disabled.
Command Modes SAN extension tuner configuration submode.
Command History Release
3.1(1)
Usage Guidelines
To use this command, you must enable the IP Network Simulator using the ips netsim enable command.
This command rate limits the size of the queue on a specified Gigabit Ethernet port. The recommended
queue size for network simulation is 50000 to 150000. If the queue becomes full, packets are dropped.
Examples The following example shows how to limit the queue size to 75 KB.
switch# config terminal
switch(config)#
switch(config)# san-ext-tuner enable
switch(config)# exit
switch#
switch# ips netsim qsize 75 ingress gigabitethernet 2/3
Related Commands Command
show ips netsim
ips netsim enable
Cisco MDS 9000 Family Command Reference
11-64
ips netsim qsize queue-size ingress gigabitethernet slot/port
Specifies the queue size. The range is 0 to 1000000.
Specifies the ingress direction.
Specifies the the slot and port number of the Gigabit Ethernet interface.
Modification
This command was introduced.
Description
Displays a summary of the interfaces that are currently operating in network
simulation mode.
Enables the IP Network Simulator.
Chapter 11 I Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x