Rscn Distribute - Cisco MDS 9000 series Command Reference Manual

rscn distribute

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
rscn distribute
To enable distribution of a Registered State Change Notification (RSCN) configuration, use the rscn
distribute command in configuration mode. To disable the distribution, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults
RSCN timer distribution is disabled.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
The RSCN timer configuration must be the same on all switches in the VSAN; otherwise, the link will
not come up. Cisco Fabric Service (CFS) automatically distributes the RSCN timer configuration to all
switches in a fabric. Only the RSCN timer configuration distributed.
For the CFS distribution to operate correctly for the RSCN timer configuration, all switches in the fabric
Note
must be running Cisco SAN-OS Release 3.0(1) or later.
Examples
The following example enables the distribution of an RSCN configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# rscn distribute
Related Commands Command
rscn abort vsan
rscn commit vsan
rscn event-tov
clear rscn session vsan Clears the RSCN session for a specified VSAN.
show rscn
Cisco MDS 9000 Family Command Reference
20-38
rscn distribute
no rscn distribute
Modification
This command was introduced.
Description
Cancels a pending RSCN configuration on a specified VSAN.
Applies a pending RSCN configuration.
Configures an RSCN event timeout.
Displays RSCN configuration information.
Chapter 20 R Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x