System Trace - Cisco MDS 9000 series Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

system trace

To configure the system trace level, use the system trace command in configuration mode. To disable
this feature, use the no form of the command.
Syntax Description
bit-mask
Defaults None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines This command is used for debugging purposes.
Examples The following example shows how to configure the system trace level.
switch# config terminal
switch(config)# system trace 0xff
OL-8413-07, Cisco MDS SAN-OS Release 3.x
system trace bit-mask
no system trace
Specifies the bit mask to change the trace level.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
system trace
21-105