Span Session - Cisco MDS 9000 series Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

span session

To configure a SPAN session, use the span session command. To remove a configured SPAN feature or
revert it to factory defaults, use the no form of the command.
Syntax Description
session-id
Defaults None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example shows how to configure a SPAN session.
switch# config terminal
switch(config)# span session 1
switch(config-span)#
The following example shows how to delete a SPAN session.
switch(config)# no span session 1
Related Commands Command
switchport
span session
destination interface
source
suspend
show span session
OL-8413-07, Cisco MDS SAN-OS Release 3.x
span session {session-id}
no span session {session-id}
Modification
This command was introduced.
Description
Configures the switch port mode on the Fibre Channel interface.
Selects or configures the SPAN session and changes to SPAN configuration
submode.
Configures a SPAN destination interface.
Configures a SPAN source.
Suspends a SPAN session.
Displays specific information about a SPAN session
Specifies the SPAN session ID. The range is 1 to 16.
Cisco MDS 9000 Family Command Reference
span session
21-45