Debug Klm - Cisco MDS 9000 series Command Reference Manual

debug klm

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug klm
To enable kernel loadable module parameter debugging, use the debug klm command in EXEC mode.
To disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
Syntax Description fc2
cpuhog seconds
flag flags
scsi-target
driver
error
vsan vsan-id
fcid fc-id
flow
snmp
syscall
sdip
all
flow
warning
Defaults
Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines None.
Cisco MDS 9000 Family Command Reference
6-74
debug klm {fc2 {cpuhog seconds | flag flags} | scsi-target {driver | error [vsan vsan-id] [fcid
fc-id] | flag flags | flow [vsan vsan-id] [fcid fc-id] | snmp | syscall} | sdip {all | error | flow |
warning}}
no debug klm {fc2 {cpuhog seconds | flag flags} | scsi-target {driver | error [vsan vsan-id] [fcid
fc-id] | flag flags | flow [vsan vsan-id] [fcid fc-id] | snmp | syscall} | sdip {all | error | flow |
warning}}
Modification
This command was introduced.
Enables debugging for FC2 driver debug parameters.
Specify the FC2 CPU hog value. The ranges is 0 to 10000 seconds.
Specify the flag values. The ranges is 0x0 to 0xffffffff.
Enables debugging for the SCSI target driver.
Enables debugging for SCSI target driver flags.
Enables debugging for driver error conditions.
Restricts debugging to the specified VSAN.
Restricts debugging to the specified FCID interface.
Enables debugging for SCSI target flow.
Enables debugging for SCSI target SNMP requests.
Enables debugging for SCSI target system call request.
Enables debugging for the SDIP driver.
Enables debugging for the SCSI target driver.
Enables debugging for driver flow.
Enables debugging for driver warnings.
Chapter 6 Debug Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x