Fspf Passive - Cisco MDS 9000 series Command Reference Manual

fspf passive

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fspf passive
To disable the FSPF protocol for selected interfaces, use the fspf passive command. To revert to the
default state, use the no form of the command.
Syntax Description
vsan vsan-id
Defaults FSPF is enabled.
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Access this command from the
By default, FSPF is enabled on all E ports and TE ports. FSPF can be disabled by setting the interface as
passive using the fspf passive command.
FSPF must be enabled on the ports at both ends of the ISL for the protocol to operate correctly.
Note
Examples The following example disables the FSPF protocol for the selected interface on VSAN 1.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf passive vsan 1
Related Commands Command
show fspf interface
show interface fcip
Cisco MDS 9000 Family Command Reference
8-80
fspf passive vsan vsan-id
no fspf passive vsan vsan-id
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified FCIP interface.
Specifies a VSAN ID. The range is 1 to 4093.
submode.
switch(config-if)#
Chapter 8 F Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x