Siemens Sinamics S120 Diagnostic Manual page 922

List of actions
Digitizing inactive /DIGITIZEOFF/ No. 54
Definitions: ! Digitize function removed !
Deactivate digitization (PI command)
Should not occur in any alarm
Digitizing processing /STARTDIGITIZE/ No. 28
Definitions: ! Digitize function removed !
Start processing in digitize submode
(VDI signal, NC start)
Not permitted if:
1. JOG motion is active,
2. An alarm response is pending:
3. Reference point approach has not yet been executed.
Possible actions:
1. None
2. Execute alarm clear condition.
3. Execute reference point approach
Disable NC program /LOCK_FOR_EDIT/ No. 81
Definitions: Block editing of the NC program
currently being processed (PI command)
Should not occur in any alarm
End of overstore buffer /OVERSTORE_BUFFER_END_REACHED/ No. 39
Definitions: Stop because the end of the overstore buffer "_N_OSTOREXX_SYF" has been reached
Should not occur in any alarm
Function generator OFF /FUNCTGENOFF/ No. 56
Definitions: 'Disable the function generator (PI command)
Should not occur in any alarm
Function generator ON /FUNCTGENON/ No. 55
Definitions: Enable the function generator (PI command)
Should not occur in any alarm
Init phase /INIIT/ No. 1
Definitions: Execute initialization phase (internal, after power on, initialization of tasks)
922
which prevents a start,
or compels braking.
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms