Block %2 Impermissible Axis Exchange In Repos Command By Axis %3; Block %2 Spindle %3 Not Available In The Channel; Block %2 Spindle %3 Cannot Be Assigned - Siemens Sinamics S120 Diagnostic Manual

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify the part program if necessary.
Program Clear alarm with the RESET key. Restart part program
Continuation:
16025 [Channel %1: ] Block %2 impermissible axis exchange in REPOS command by axis %3.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis identifier
Definitions: With the REPOS command, an axis or spindle was programmed that was in the NEUTRAL state at that time. As the
REPOS command cannot execute any implicit GET, these axes/spindles cannot be
repositioned. Part program editing is therefore aborted.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Assign the axes/spindles that are to be repositioned to the channel via GET command prior to the REPOS command.
Example:
GET(A); assign the A axis to the channel
REPOSL A; reposition the geometry axes and A axis
Program Clear alarm with the RESET key. Restart part program
Continuation:
16100 [Channel %1: ] Block %2 spindle %3 not available in the channel
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Incorrect programming:
This channel does not recognize the spindle number.
The alarm can occur together with a dwell or a spindle function.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
Check the part program to determine whether the programmed spindle number is correct and whether the program is
run in the correct channel.
Check MD35000 $MA_SPIND_ASSIGN_TO_MACHAX for all machine axes to see whether one of them contains the
programmed spindle number. This machine axis number must be entered in a channel axis of the machine data
MD20070 $MC_AXCONF_MACHAX_USED.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16105 [Channel %1: ] Block %2 spindle %3 cannot be assigned
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming: The programmed spindle is not assigned a real spindle by the spindle number converter. The
alarm can be issued after improper use of SD42800 $SC_SPIND_ASSIGN_TAB[].
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
221