Block %2: Check Measuring Direction; Block %2: Program Reset Required/Block %2: Check D Number; Block %2: Check Rotary Axis/Block %2: Coordinate Rotation Active; Block %2: Angle Too Large, Change Measuring Axis - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
61326 [Channel %1: ] Block %2: Check measuring direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE973, CYCLE976.
Remedy: Parameter for measuring direction _MD has an incorrect value.
61327 [Channel %1: ] Block %2: Program reset required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: NC reset required.
Alarm is triggered: all measuring cycles except for CYCLE973, CYCLE976.
Remedy: Execute NC reset.
61328 [Channel %1: ] Block %2: Check D number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: D number in parameter _KNUM is 0.
The alarm can be triggered by all measuring cycles.
Remedy: Check parameter for tool offset target (_KNUM)
61329 [Channel %1: ] Block %2: Check rotary axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE998
Remedy: No name assigned to the axis number specified in the parameter of the rotary axis (_RA), or this axis is not configured
as a rotary axis.
Check MD 20080 and MD 30300.
61330 [Channel %1: ] Block %2: Coordinate rotation active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No measuring possible in the rotated coordinate system. Alarm is triggered: CYCLE972, CYCLE973, CYCLE974,
CYCLE994.
Remedy: Check the conditions for measuring.
61331 [Channel %1: ] Block %2: Angle too large, change measuring axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameter starting angle (_STA) is too large for the specified measuring axis. Alarm is triggered: CYCLE998.
Remedy: Select another metering axis.
436
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms