Workpiece Setpoint %2 Reached - Siemens Sinamics S120 Diagnostic Manual

21760 [Channel %1: ] Block %2 too many auxiliary functions programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The number of programmed auxiliary functions has exceeded the maximum permissible amount. This alarm can occur
in conjunction with motion synchronous actions: The maximum number of auxiliary functions must not be exceeded in
motion block and motion synchronous actions.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
21800 [Channel %1: ] Workpiece setpoint %2 reached
Parameters: %1 = Channel number
%2 = Workpiece setpoint
Definitions: This alarm is activated via MD27880 $MC_PART_COUNTER, bit 1: The number of counted workpieces
($AC_ACTUAL_PARTS or $AC_SPECIAL_PARTS) is equal or already greater than the programmed value for the
number of required workpieces ($AC_REQUIRED_PARTS). At the same time, the channel VDI signal "Workpiece set-
point reached" is output. The value for the number of counted workpieces ($AC_ACTUAL_PARTS) is reset, while the
value of $AC_SPECIAL_PARTS is retained.
Note:
The setpoint/actual comparisons of the workpieces are only made after an NC start
under the condition that $AC_REQUIRED_PARTS > 0. If $AC_REQUIRED_PARTS
has a negative value, all workpiece counts activated through MD27880 $MC_PART_COUNTER are frozen at the val-
ues they have reached,
and the nominal/actual comparison is discontinued.
Reaction: NC not ready.
Interface signals are set.
Alarm display.
Remedy: No program interrupt. Delete alarm display.
Program Clear alarm with the Delete key or NC START.
Continuation:
22000 [Channel %1: ] Block %2 Spindle %3 Gear stage change in %4 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
%4 = Gear stage
Definitions: A gear stage change for the spindle will not be possible, if:
- thread cutting (G33, G34, G35) is active
- the spindle is active as master or slave spindle in a coupling
- the spindle is being positioned
Reaction: Interpreter stop
NC Start disable in this channel.
NC Stop on alarm.
Interface signals are set.
Alarm display.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
325