Block %2 Contour Tool: Impermissible Tool Contour Change. Code No. %3; Block %2 Contour Tool: Angle Area Of Edge D%3 Larger Than 359 Degrees; Block %2 Reload Buffer %3 Cannot Be Established - Siemens Sinamics S120 Diagnostic Manual

Remedy: Change the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14550 [Channel %1: ] Block %2 contour tool: impermissible tool contour change. Code no.
%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: A new tool with deviating tool contour was activated for contour tools on active tool radius compensation
The error cause is explained further by an error code.
If the error code is an integer, the lower-value three decimal places specify the number of the edge, in which the error
was detected, while the thousandth digit explains the reason in more detail.
-1: The tool was deleted.
-2: The number of contour elements (edges) explaining the tool, has changed.
1000: The edge center has changed
2000: The edge radius has changed.
3000: The initial angle has changed.
4000: The final angle has changed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14551 [Channel %1: ] Block %2 contour tool: angle area of edge D%3 larger than 359 degrees
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: A single edge must cover a max. angle area of 359 degrees.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Check tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14600 [Channel %1: ] Block %2 reload buffer %3 cannot be established
Parameters: %1 = Channel number
%2 = Block number, label
%3 = File name
Definitions: The download buffer for "execute from external" could not be created. Possible causes:
- Not enough memory available (for minimum see MD18360 $MN_MM_EXT_PROG_BUFFER_SIZE)
- No resources available for HMI NCK communication (see MD18362 $MN_MM_EXT_PROG_NUM)
- The file already exists
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
187