Block %2 Coupling Of Axis %3 Prohibits Transformation Change; Block %2 Coupling Prohibits Reference Point Approach; Block %2 String Cannot Be Interpreted; Block %2 Coupling Not Defined - Siemens Sinamics S120 Diagnostic Manual

16793 [Channel %1: ] Block %2 coupling of axis %3 prohibits transformation change
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The specified axis is a slave axis in a transformation grouping. When the coupling is switched on, the transformation
cannot be changed to another one.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Switch off coupling(s) of this axis before changing transformation or do not change the transfor-
mation.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16794 [Channel %1: ] Block %2 coupling of axis/spindle %3 prohibits reference point
approach
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The specified axis is a (gantry) slave axis and cannot therefore approach the reference point.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Switch off coupling(s) of this axis before reference point approach or do not reference. A gantry
slave axis cannot reference for itself.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16795 [Channel %1: ] Block %2 string cannot be interpreted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A coupling has been switched on in which a non-interpretable string has been written (e.g. block change behavior).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16796 [Channel %1: ] Block %2 coupling not defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A coupling is to be switched the parameters of which have neither been programmed nor configured.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Correct NC part program or MD, program the coupling
with COUPDEF or configure by means of MD.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
247