Cutter Radius Too Small; Calculation Has Been Cancelled; Combination Of Centering/Predrilling And Spigot Not Allowed - Siemens Sinamics S120 Diagnostic Manual

61915 %[[Channel %1: ] Block %2: %]Cutter radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check the radius of the milling cutter in tool management
Program Clear alarm with the RESET key. Restart part program
Continuation:
61916 %[[Channel %1: ] Block %2: %]Calculation has been cancelled
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Calculation has been cancelled by PI service; please try again
Program Clear alarm with the RESET key. Restart part program
Continuation:
61917 %[[Channel %1: ] Block %2: %]Combination of centering/predrilling and spigot not
allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Machining of spigot in conjunction with predrilling/centering not allowed!
Program Clear alarm with the RESET key. Restart part program
Continuation:
61918 %[[Channel %1: ] Block %2: %]Cut. radius for residual mach. must be smaller than cut.
radius for ref. tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
483