The Max. Number Of Characters Per Line Is Limited To 200; The Maximum Number Of Characters Per Line _Protform Is Adjusted; Block %2: Probe Is Not Perpendicular To Plane; The Number Of Lines Per Page _Protform Is Incorrect - Siemens Sinamics S120 Diagnostic Manual

62310 [Channel %1: ] Block %2: The max. number of characters per line is limited to 200
characters per line
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE105.
The maximum number of characters per line has been limited to 200 characters per line.
Remedy: --
62311 [Channel %1: ] Block %2: The maximum number of characters per line _PROTFORM[1]
is adjusted.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycles: CYCLE105
Max. number of characters per line _PROTFORM[1] has been adjusted.
Reaction: Alarm display.
Remedy: --
Program Clear alarm with the Delete key or NC START.
Continuation:
62312 [Channel %1: ] Block %2: probe is not perpendicular to plane!
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Alarm display.
Remedy: --
Program Clear alarm with the Delete key or NC START.
Continuation:
62313 [Channel %1: ] Block %2: The number of lines per page _PROTFORM[0] is incorrect
and is automatically adjusted.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycle: CYCLE106.
Remedy: Check _PROTFORM[0] in the program.
62314 [Channel %1: ] Block %2: Traverse path limitation via software end position, collision
detection activated, continue with NC START / cancel with RESET.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE977
Remedy: Position the workpiece to be measured further away from the software end positions.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
497