Block %2: Probe Not Switching; Block %2: Probe - Collision; Block %2: Safety Margin Exceeded; Block %2: Allowance / Block %2: Dimension Too Small - Siemens Sinamics S120 Diagnostic Manual

61301 [Channel %1: ] Block %2: Probe not switching
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The measuring distance was completely traversed, but no switching signal was generated at the measuring input.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: -Check measuring input.
-Check measuring distance.
-Probe defective.
61302 [Channel %1: ] Block %2: Probe - collision
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The measuring probe collided with an obstacle when being positioned.
Alarm can be triggered by the following measuring cycles: all measuring cycles.
Remedy: - Check spigot diameter (may be too small)
- Check measuring distance (may be too long)
61303 [Channel %1: ] Block %2: Safety margin exceeded
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The measuring result differs greatly from the specified value.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: - Check setpoint value and parameter _TSA
61304 [Channel %1: ] Block %2: Allowance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Clear alarm with the RESET key. Restart part program
Continuation:
61305 [Channel %1: ] Block %2: Dimension too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
431