Island Contour Existing Twice; Spigot Contour Existing Twice; No Material Available For Machining - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
Remedy:
- Check parameter for plane infeed
- for G17: DXY
- for G18: DZX
- for G19: DYZ
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61946
%[[Channel %1: ] Block %2: %]Island contour existing twice
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Delete double island contour
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61947
%[[Channel %1: ] Block %2: %]Spigot contour existing twice
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Delete double spigot contour
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61948
%[[Channel %1: ] Block %2: %]No material available for machining
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the contours
Program
Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
489
Hide quick links:
Advertisement
Table of Contents
