Block %2 Machining Stop After Lift Fast; Block %2 Wrong Axis Identifier %3; Block %2 No Retraction Position Programmed For Axis %3 - Siemens Sinamics S120 Diagnostic Manual

Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16010 [Channel %1: ] Block %2 machining stop after lift fast
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel is stopped after the lift motion has
been carried out.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: After the channel stop, the axes must be retracted manually in JOG and the program aborted with Reset.
Program Clear alarm with the RESET key. Restart part program
Continuation:
16015 [Channel %1: ] Block %2 wrong axis identifier %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Axis names from different coordinate systems were used to program axes for LIFTFAST. The retraction movement is
no longer clear.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use axis names from one coordinate system.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16016 [Channel %1: ] Block %2 no retraction position programmed for axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: The retraction enable was programmed for LIFTFAST without defining a retraction position for the axis. The retraction
movement is no longer clear.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program a retraction position for the relevant axis.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
219