Fujitsu Eternus DX100 S3 User Manual page 873

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED28F
ED290
ED291
ED292
ED293
ED294
ED295
ED296
ED297
ED298
ED299
ED29A
ED29B
ED29C
ED29D
ED29E
ED29F
ED2A0
ED2A1
The network information is being set.
The network information is being set. Wait for a while and try again.
No controller firmware can be downloaded.
No controller firmware can be downloaded.
The information of the device is being sent again because outdated information is registered in the
remote support center. Wait approximately ten minutes and try again.
The information of the ETERNUS DX is being sent again because outdated information is registered in the
remote support center. Wait approximately ten minutes and try again.
An error occurred during HTTP communication.
An error occurred during http communication.
An error occurred during SMTP communication.
An error occurred during SMTP communication.
A communication error occurred.
A communication error occurred.
No log files exist.
No log files exist (the timeout interval for this error is five minutes.)
The specified SLU does not exist.
An SLU number that is not configured is specified.
Data cannot be obtained because of a cache miss.
Data cannot be obtained because of a cache miss.
The cache data cannot be obtained because the specified mirror cache does not exist.
The cache data cannot be obtained because the specified mirror cache does not exist.
The cache data cannot be obtained because the cache of the drive that is specified contains dirty data.
The cache data cannot be obtained because the cache of the drive that is specified contains dirty data.
Even though the CCHH mode is specified, the relevant volume is not a Mainframe volume or a MVV vol-
ume.
Even though the CCHH mode is specified, the relevant volume is not a Mainframe volume or a MVV vol-
ume.
Specified Head Number is incorrect.
The specified Head value is incorrect.
Specified CCHH or SLBA is out of range.
The specified SLU-LBA or CCHH is not within the range of the SLU-LBA.
The LU type of the specified SLU is TPPC, FTV, or TMP FTV
The LU type of the specified SLU is TPPC, FTV, or TMP FTV
The storage is in "Machine Down" state.
The ETERNUS DX is in Machine Down status.
Status of target RAID Group is not Broken.
The specified RAID group is not in Broken status.
The access path to the specified RAID group is not normal.
The access path to the specified RAID group is not normal.
There is no access path to the target RAID Group.
The specified RAID group is blocked.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
873
P2X0-1210-05ENZ0