Fujitsu Eternus DX100 S3 User Manual page 528

Chapter 5 System Settings and Display
5.2 Network Management > set snmp-user
-encryption-method
■
Example(s)
The following example sets user FooVar to SNMP view "xview4":
CLI> set snmp-user -user FooVar -view xview4
In the following example, user FooVar is set to SNMP view "xview4", the authentication method is set to
MD5, and encryption is enabled:
CLI> set snmp-user -user FooVar -view xview4 -authentication enable -authentication-method md5
Current Authentication Password:
New Authentication Password:
Confirm Authentication Password:
Current Encryption Password:
New Encryption Password:
Confirm Encryption Password:
Optional. This parameter specifies the encryption method. If this parameter is omitted, the
DES encryption method is used.
This parameter can be specified only when the encryption function is enabled.
des DES encryption method (Default)
aes AES encryption method (Default)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
528
P2X0-1210-05ENZ0