Fujitsu Eternus DX100 S3 User Manual page 329

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set lun-group
-lun
■ Example(s)
The following example changes the LUN group named "LUN001". The new name is "NEW_LUN002":
CLI> set lun-group -lg-name LUN001 -name NEW_LUN002
In the following example, the first command creates the LUN group named "LUN001". This LUN group will
contain a definition of the association of consecutive volumes #0 – #10 and consecutive LUNs #0 – #10. The
second command adds other definitions to the LUN group. Consecutive volumes #101 – #105 will be
associated with LUNs #11 – #15. Existing definitions are retained after the second command is executed.
Only the definitions specified in the second command are added:
CLI> create lun-group -name LUN001 -volume-number 0-10 -lun 0-10
CLI> set lun-group -lg-name LUN001 -volume-number 101-105 -lun 11-15
Optional. This parameter specifies LUNs to add a definition to the specified LUN group, and is
paired with volume identifiers. If omitted, the existing setting is not changed. If two or more
volume identifiers are specified, these parameters must be specified in the same order as the
associated LUNs. Any already assigned definitions cannot be specified. LUNs that are defined
in the specified LUN group cannot be specified. Two or more parameters can be specified by
separating them with a comma (,), a hyphen (-), or both.
Example: -lun 0,1 -lun 0-10 -lun 1,6-8
luns Host LUN
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
329
P2X0-1210-05ENZ0