Fujitsu Eternus DX100 S3 User Manual page 831

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E0113
E0114
E0115
E0116
E0117
E0118
E0120
E0122
E0123
E0131
E0132
E0133
E0140
E0141
E0142
No SNMP trap information.
Could not execute because SNMP trap information is not registered. Check the SNMP trap information by
using the "show snmp-trap" command.
Create SNMP trap information by using the "create snmp-trap" command if necessary.
No volumes in the RAID Group / Thin provisioning pool.
There are no volumes in the specified RAID group or Thin Provisioning Pool. Check the number of volumes
in the specified RAID group or Thin Provisioning Pool by using the "show raid-groups" command or the
"show thin-pro-pools" command
Performance monitor has not started.
Collecting performance information has not started. Start collecting performance information by using
the start-performance command.
The system disks are included in the RAID group.
System disks exist in the RAID group.
No target disks.
The target disks do not exist. Confirm the disk status or details by using the "show disks" command.
Remote Copy target is not supported model.
The specified storage system is not supported for Remote Equivalent Copy. Check whether or not to specify
an appropriate storage system.
Already registered.
The resource is already registered. Check the status of the object shown in the details of this message.
Closure of all CLI and GUI ports requires confirmation.
Displayed when all the connections methods for both the CLI and GUI are to be disabled. If this is
intentional, retry the command with the "-confirm-close-all yes" parameter specified to make the storage
system inaccessible via CLI or GUI.
Closure of all CLI ports requires confirmation.
Displayed when all the CLI connection methods are to be disabled. If this is intentional, retry the
command with the "-confirm-close-all yes" parameter specified to make the storage system inaccessible
via CLI.
Already unmapped.
Resources corresponding to the specified parameter are already unmapped. Check the resources
identified in the details of this message.
Already stopped.
Resources corresponding to the specified parameter are already stopped. Check the resources identified in
the details of this message.
Already running for expanding others.
The relevant operation has been already executed with another resource.
One or more components have failed.
One or more components have failed during the maintenance operation. Check the reason for the failure
or take log files and ask the support department to investigate.
At least one resource is required.
At least one or more resources are required. Check the specification.
One or more encrypted volumes exist.
Cannot execute this command because encrypted volumes exist. Please check the status of volumes by
using the "show volumes" command.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
831
P2X0-1210-05ENZ0