Fujitsu Eternus DX100 S3 User Manual page 353

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-response
-tpg-referrals
-prhl-dev-type
-flat-prhl-dev-type
-scsi-version
-naca
Optional. This parameter specifies whether to enable the TPG Referrals. When "enable" is set
for this parameter, TPG Referrals are only performed when TPGS is enabled and Asymmetric/
Symmetric Logical Unit Access is set to ACTIVE/ACTIVE-PRFERRED_PATH.
Set "enable" for this parameter only for connection environments in which
the ETERNUS Multipath Driver that is being used supports TPG Referrals.
enable TPG Referrals is enabled.
disable TPG Referrals is disabled (default).
Optional. This parameter specifies the Byte-0 value for the Inquiry command response. If this
parameter is omitted, the existing setting remains unchanged.
no-dev-type The Byte-0 value is converted to "0x3F (No Device Type)" for the response.
(default).
no-support The Byte-0 value is converted to "0x7f (Not Supported)" for the response.
no-connect The Byte-0 value is converted to "0x20 (Not Connected)" for the response.
Optional. This parameter specifies the peripheral device type for LUN0 when the Flat Space
Addressing mode is used.
no-dev-type No Device Type (3Fh) (default)
ctrl-dev Controller Device (0Ch)
Optional. This parameter specifies the data version of the Inquiry Standard. If this parameter is
omitted, the existing setting remains unchanged.
6 The data version is 6th (default).
5 The data version is 5th.
4 The data version is 4th.
3 The data version is 3rd.
Optional. This parameter specifies whether the NACA bit is set. If this parameter is omitted, the
existing setting remains unchanged.
on The NACA bit is set.
off The NACA bit is not set.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
353
P2X0-1210-05ENZ0