Show Host-Iscsi-Names - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-iscsi-names

show host-iscsi-names

This command displays a list of the iSCSI hosts registered in the system. When iSCSI host identifiers are
specified, iSCSI host details of the specified iSCSI host identifiers are displayed:
■ Syntax
show host-iscsi-names [-host-number
■ Parameter
-host-number
or
-host-name
■ Output
When the iSCSI host identifier parameter is omitted, then an iSCSI host summary list for all the iSCSI host
identifiers is displayed:
Host
Host Response
IP Address
iSCSI Name iSCSI host name which corresponds to an HBA
CmdSN Count
host_numbers
Optional. This parameter specifies which iSCSI host identifier(s) details are to be displayed.
One or more identifiers can be specified at the same time. If omitted, a summary list is
displayed. For details, refer to
host_numbers
iSCSI host number
host_names
iSCSI host name
Host identifiers
No. Host number
Name Host nickname
Assigned host response identifiers
No. Assigned host response number
Name Assigned host response name
IP address which corresponds to an HBA. If the IP address is not specified, the * mark is
displayed. When the IP address format is IPv4, "*(IPv4)" is displayed. When the IP
address format is IPv6, "*(IPv6)" is displayed.
Number of commands that can be accepted at the same time
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_names
| -host-name
"1.2.11 Host Syntax" (page
271
]
27).
P2X0-1210-05ENZ0