Fujitsu Eternus DX100 S3 User Manual page 496

Chapter 5 System Settings and Display
5.2 Network Management > set network
-ip-format
-ipv6-set-auto
-master-ip
-slave-ip
Optional. This parameter specifies the format of the IP address that is to be set. If omitted, IPv4
is selected. This parameter can be specified when "maintenance" or "remote" is specified for
the "-port" parameter.
v4 The IPv4 setting is performed.
v6 The IPv6 setting is performed.
Optional. When "enable" is selected, the link local IP address, the connect IP address, and
gateway are set automatically. If omitted, it is handled as if "disable" is selected. This parame-
ter can only be specified when "v6" is specified for the "-ip-format" parameter.
enable IPv6 automatic setting is performed.
disable IPv6 automatic setting is not performed.
Optional. This parameter specifies the IP address of the master CM. The format is IPv4 standard
notation (a base 256 "d.d.d.d" string). If omitted, the existing setting is not changed. This
parameter can only be specified when "v4" is specified for the "-ip-format" parameter.
Example: -master-ip 192.168.1.1
• If the slave IP address is active, both master/slave IP addresses must belong to the same
subnet address.
• When "0.0.0.0" is set, the IPv4 settings for the port are disabled.
• When both IPv4 and IPv6 settings are disabled, the port becomes disabled. (With the
ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F, if no other ports can be used other
than the corresponding port, both IPv4 and IPv6 settings cannot be disabled. Both the
maintenance port and the remote port must be enabled for the ETERNUS DX500 S3/DX600
S3.)
ip_address IP address of the master CM
Optional. This parameter specifies the IP address of the slave CM. The format is IPv4 standard
notation (a base 256 "d.d.d.d" string). This parameter cannot be specified for the ETERNUS DX
with a single controller. If omitted, the existing setting is not changed. This parameter can
only be specified when "v4" is specified for the "-ip-format" parameter.
Example: -slave-ip 192.168.1.2
Both the master/slave IP addresses must belong to the same subnet address.
ip_address IP address of the slave CM
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
496
P2X0-1210-05ENZ0