Fujitsu Eternus DX100 S3 User Manual page 407

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > set advanced-copy-parameters
-ec-opc-priority
-warning
-copy-schedule-mode
■ Example(s)
The following example sets up Advanced Copy parameters. The resolution is set to twice the default, the
table size is set to 128MB, and the EC/OPC priority is set to automatic mode.
CLI> set advanced-copy-parameters -resolution 2 -table-size 128 -ec-opc-priority auto
Optional. This parameter specifies the EC/OPC rate mode (EC/OPC priority). The initial value is
"auto". If omitted, the existing setting is not changed.
auto Automatically (default)
very-low Very low priority
low Low priority
middle Middle priority
high High priority
Optional. This parameter specifies the threshold value for Advanced Copy table usage. This
value is indicated by percent (%). The initial value is set to 80%. If omitted, the existing setting
is not changed. In addition, the system has a function that notifies users when this value
reaches the specified upper limit value. This upper limit value is set by using this parameter.
For details, refer to the "show event-notification" command.
warning_level
Threshold value for Advanced Copy table usage
Optional. This parameter specifies the Copy Schedule Mode. If omitted, the existing setting is
not changed.
session-balancing
Session balancing is performed.
dst-rg-balancing
Destination RAID Group balancing is performed.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
407
P2X0-1210-05ENZ0