Fujitsu Eternus DX100 S3 User Manual page 506

Chapter 5 System Settings and Display
5.2 Network Management > set firewall
-snmp
-rcil
-eternus-dx-discovery
-confirm-close-all
Optional. This parameter specifies if the "SNMP" application port is opened or closed. If
omitted, the existing setting is not changed. This parameter cannot be specified when "-port
fst" is specified. The initial state is "open".
open Application port "SNMP" is opened.
close Application port "SNMP" is closed.
Optional. This parameter specifies if the "RCIL" application port is opened or closed. If omitted,
the existing setting is not changed. This parameter cannot be specified when "-port remote" or
"-port fst" is specified. The initial state is "open".
open Application port "RCIL" is opened.
close Application port "RCIL" is closed.
Optional. This parameter specifies whether to enable the port for connecting to the ETERNUS
DX that is connected to the network with the Remote Installation function.
This parameter can only be used for the MNT port.
open ETERNUS DX Discovery is enabled.
close ETERNUS DX Discovery is disabled.
Optional. Specify "-confirm-close-all yes" to disable all of the service ports for both GUI and CLI
connections.
This parameter must be specified in either of the following cases:
•
When disabling all of the service ports for both GUI and CLI connections (HTTP, HTTPS, telnet, and
SSH)
•
When disabling both of the service ports for CLI connections (telnet and SSH)
In all other cases, this parameter is ignored. For example, if a command such as "set firewall -
port remote -icmp close -confirm-close-all no" is entered, the command is executed with
exactly the same result as if the ICMP service protocol was disabled normally.
yes Only required when all of the GUI and CLI related service ports are disabled.
no Handled as "no operation".
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
506
P2X0-1210-05ENZ0