Fujitsu Eternus DX100 S3 User Manual page 244

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-isns-server-ip
-isns-server Optional. This parameter specifies whether or not an iSNS server is used. If omitted, the
-isns-server-port
-chap
-chap-user
Optional. This parameter specifies the IP address of an iSNS server (*1) using IPv4 standard
notation (a base 256 "d.d.d.d" string) or IPv6 format. The types of IP addresses that can be
specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. IP addresses in IPv4 format can be specified when "enable" is specified for the
"-ipv4-flag" parameter. IP addresses in IPv6 format can be specified when "enable" is specified
for the "-ipv6-flag" parameter. The iSNS server must belong to the same iSCSI network as the
one to which the iSCSI interface port specified by the "-port" parameter belongs. If omitted, the
existing setting is not changed. This parameter cannot be specified when the port is set to the
RA mode.
This parameter can be specified as a parameter for the multiple IP address setting.
*1: iSNS server: Internet Storage Name Server
Example: -isns-server-ip 10.1.1.12
Example: -isns-server-ip fe80::250
isns_server_ip
IP address of an iSNS server
existing setting is not changed.
This parameter can be specified as a parameter for the multiple IP address setting.
The iSNS server can be enabled for up to four ports, including the physical ports and the virtual
ports in a single port.
enable An iSNS server is used.
disable An iSNS server is not used.
Optional. This parameter specifies iSNS server port number. The default iSNS server port
number value is 3205. This parameter cannot be specified when the port is set to the RA mode.
This parameter can be specified as a parameter for the multiple IP address setting.
isns_server_port_number
iSNS server port number (0 – 65535)
Optional. This parameter specifies whether or not CHAP authentication is used. If omitted, the
existing setting is not changed.
enable A CHAP authentication is used.
disable A CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. Up to 255 alphanumerical characters and symbols for CA ports
and up to 63 alphanumerical characters and symbols for RA ports can be used. If this
parameter is specified, then the command displays a CHAP user password prompt. If omitted,
the existing setting is not changed. To delete a registered CHAP user name, specify a null
character ("").
chap_user_name
User name for CHAP authentication
"" The registered CHAP user name is deleted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
244
P2X0-1210-05ENZ0