Fujitsu Eternus DX100 S3 User Manual page 841

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5208
E5209
E5210
E5211
E5212
E5213
E5214
E5215
E5216
E5217
E5300
E5301
E5302
E5303
E5304
E5305
E5306
E5307
E5308
Copy license information updating due to trial license expired.
The copy license information is being updated. Wait for a while and try again.
Not support E6K to target of REC.
Consistency sessions are not supported for remote storage systems.
Data in disk buffer.
Data exists in the disk buffer. Check the disk buffer by using the "show rec-buffer" command.
The raid group is for REC disk buffer.
The specified RAID group is configured with an REC disk buffer. Check the RAID group by using the "show
rec-disk-buffer" command.
Source and destination RA type is not match.
The RA type does not match for the copy source and copy destination devices in the REC path settings.
Check the contents of the settings for the path file.
The times registering trial license has been reached the system limit.
The limit for the number of times that the trial license can be registered has been reached.
Exist RA.
The RA is set. Check the RA by using the "show host-port-mode" command.
Result string is too long.
The CLI execution result in the remote terminal exceeds the predetermined size.
Compete for the affinity path.
A conflict occurred in an affinity port.
The specified multiplicity or priority level mismatch connect mode (Direct/Switched) of the REC path.
The connected path type is different from the specified condition of the parameter.
An error occurred in the copy path connection.
An error (timeout or blockage) occurred during communication between the ETERNUS DX storage
systems.
An unsupported command was issued by the remote storage.
The remote ETERNUS storage system issued a command that the local ETERNUS DX does not support.
The specified volume number is not correct (exceeding the maximum volume number).
A number that is larger than the maximum value for the configuration is specified for the LU.
The specified volume is not Standard, SDV or TPV.
The LU type is not OLU, SDV, or TPPC.
Advanced copy cannot be set to the specified volume.
A copy session cannot be set for the LU.
There is "Bad Sector" in the copy source volume.
The copy source volume contains a bad sector.
Encryption settings of copy source volume and copy destination volume are different.
The encryption settings of the copy source LU and the copy destination LU are different.
The copy source volume and copy destination volume don't belong to the same resource domain.
The resource domain number for the copy source LU and the copy destination LU are different.
The specified volume is a "Temporary".
The LU is a dummy volume. A dummy volume is a volume that remains after RAID Migration fails.
A restoration copy cannot be set for a session that is to be restored because the session will be deleted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
841
P2X0-1210-05ENZ0