Fujitsu Eternus DX100 S3 User Manual page 380

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos
WWN/iSCSI Name/SAS Address
When the Host QoS settings are displayed with the target host specified
Host
Bandwidth Limit
Host Type
WWN/iSCSI Name/SAS Address
No.
Schedule No.
Bandwidth Limit
When the LU Host-LU QoS settings are displayed
Port (Bandwidth Limit)
Host
LUN (Bandwidth Limit)
■ Example(s)
The following example displays the LU Host-LU QoS settings:
CLI> show host-lu-qos
Port (Bandwidth Limit) Host
---------------------- ---- ---------------------- ------
CM#0 CA#0 Port#0 ( 0)
CM#0 CA#0 Port#0 ( 0)
CM#0 CA#1 Port#0 ( 2)
CM#1 CA#0 Port#0 ( 3)
CM#1 CA#0 Port#0 ( 3)
CM#1 CA#1 Port#0 (15)
WWN (for FC/FCoE), iSCSI name (for iSCSI), or SAS address (for SAS) of the host
Host identifiers
No. Host number
Name Host name
Bandwidth limit (upper limit performance value) for the host
Host type
WWN (for FC/FCoE), iSCSI name (for iSCSI), or SAS address (for SAS) of the host
Event number of the QoS schedule
QoS schedule number for the host
Bandwidth limit (upper limit performance value) of the QoS schedule for the host
Host interface port (and its bandwidth limit (upper limit performance value))
Host identifiers
No. Host number
Name Host name
(Bandwidth Limit)
Bandwidth limit (upper limit performance value) for the host
Bandwidth limit (upper limit performance value) for the host
(Bandwidth Limit) LU QoS
No. Name
0 Host#FC_0
2 Host#FC_1
0 Host#iSCSI_0
0 Host#FC_0
2 Host#FC_1
0 Host#iSCSI_0
380
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Group
( 0) -
( 1) 2
( 5) 2
( 0) 3
( 1) 3
( 5) 2
P2X0-1210-05ENZ0