Test Iscsi-Ping - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > test iscsi-ping

test iscsi-ping

This command issues a ping command from the specified host interface port to the specified iSCSI host.
• When a response is successfully returned for the ping command, "Success" is displayed.
• When a response is not returned for the ping command, "Failure" is displayed and this CLI command
abnormally terminates with an error message.
• Note that when a response is not returned for a connection between the host and the specified port fails
to link up, only "Failure" is displayed. No error messages are displayed.
■ Syntax
test iscsi-ping -port
■ Parameter
-port
-ip
-count
-additional-ip
xyz iscsi_host
-ip [-count
This parameter specifies the source host interface port used to issue the ping command. Only
one host interface port can be specified at any given time.
Example: -port 000
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the
iSCSI port number.
Example: "123" indicates CM#1-CA#2-Host port#3
This parameter specifies the IP address of the target iSCSI host using IPv4 standard notation (a
base 256 "d.d.d.d" string) or IPv6 format. The types of IPv6 addresses that can be specified are
global addresses (including 6to4 addresses), link local addresses, and unique local addresses.
Only one iSCSI host can be specified at any given time.
iscsi_host
IP address of the target iSCSI host
Optional. This parameter specifies the number of times that the ping command is to be issued.
Any value between 1 and 10 can be specified. If omitted, this parameter value defaults to 1.
count
Number of times that the ping command is to be issued (1 – 10)
Optional. This parameter specifies the virtual port information number of the port for which
the virtual port information is enabled. If this parameter is omitted, "0" (this indicates the
actual port information) is set for the value of this parameter.
Only one virtual port information number can be specified.
additional-ip
Virtual port information number (1 – 15)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
count additional-ip
] [-additional-ip
367
]
29).
P2X0-1210-05ENZ0