Set Encryption - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.3 System Settings > set encryption

set encryption

This command specifies whether encryption mode is enabled or disabled. When the encryption mode is
enabled, "Fujitsu" or "AES" should be specified as the kind of encryption. After switching the encryption mode
from enabled to disabled, the ETERNUS DX power must be turned off and back on again to apply the setting.
When switching the encryption mode from disabled to enabled, this operation is not required.
Encryption-related functions may not be available for some user environments.
■
Syntax
set encryption -mode {fujitsu | aes | disable}
■ Parameter
-mode
■ Example(s)
The following example enables the Fujitsu encryption mode function:
CLI> set encryption -mode fujitsu
The following example disables the encryption mode functions, and then reboots the ETERNUS DX to apply
the setting:
CLI> set encryption -mode disable
CLI> shutdown -mode reboot
This parameter specifies encryption mode.
fujitsu Encryption mode is enabled. (Fujitsu)
aes Encryption mode is enabled. (AES)
disable Encryption mode is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
613
P2X0-1210-05ENZ0