Fujitsu Eternus DX100 S3 User Manual page 842

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5309
E5310
E5311
E5312
E5313
E5314
E5315
E5316
E5317
E5318
E5319
E5320
E5321
E5322
Disk failure occurred while the relevant copy session is in "Suspend" state. The copy session turns into
"Error" state.
The session transitioned to error status because the drive in SUSPEND status failed.
Parameter error occurred.
Parameter error (incorrect settings).
Source volume whose capacity is larger than destination volume's cannot be specified.
The copy source LU is larger than the copy destination LU for all of the copy sessions.
It failed to reverse the copy session.
The relevant session could not be reversed or its mode could not be changed.
Copy range conflicts with the existing RAID migration session.
The scope of the copy session overlaps the scope of the existing RAID Migration session.
The specified copy range of the copy source volume is overlap with the copy range in an existing session
(excluding cascade and restore).
The copy source LU area is the same as the copy destination LU area for the existing copy session
(excluding cascade copy sessions and restoration copy sessions).
The specified copy range of the copy destination volume is overlap with the copy range in an existing
session (excluding cascade and restore copy).
The copy destination LU area is the same as the copy source LU area for the existing copy session
(excluding cascade copy sessions and restoration copy sessions).
The specified cascade copy cannot be done.
The scope for the cascade copy is out of the allowed range.
The copy session which is in progress of restoring was specified.
A restoration copy session is attempted to be restored.
The number of cascades exceeds the maximum.
The number of cascade connection linkages exceeds the upper limit (1).
An "Error Suspend" session was specified.
The restoration copy is attempted with Concurrent OPC and the session that is specified for this
restoration copy is in ErrorSuspend state or in the Readying phase.
Multiple copy sessions in REC Consistency mode cannot operate in a single storage.
A multiple copy in REC Consistency mode is attempted in a single ETERNUS DX (this type of multiple copy
is allowed when one of the copy sessions is suspended).
The state of the specified session is not correct.
The relevant session has been deleted.
The status of the QuickOPC session is not Active or Copying when the session restarts.
The SUSPEND command is issued when the status of the relevant session is not Active/Equivalent. (This
does not apply when an REC session is forcibly specified.)
The SUSPEND command is issued when the status of the relevant (REC) session is ErrorSuspend or Halt
and when the status of the REC buffer is Buffering (this also applies when an REC session is forcibly
specified).
The CHANGE command is issued when the status of the relevant session is not Suspend.
A command was issued while processing CONCURRENT SUSPEND command.
A command is issued while the CONCURRENT SUSPEND command transitions the asynchronous session
status to Suspend.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
842
P2X0-1210-05ENZ0