Delete Nas-Route6 - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.5 Network Settings > delete nas-route6

delete nas-route6

This command deletes an IPv6 static route that has been set using the "set nas-route6" command. The static
routes that can be deleted by this command are the routes that can be displayed by executing the "show nas-
route6 -mode startup" command.
■ Syntax
delete nas-route6 {{-ip
gateway_address
-gw
■
Parameter
-ip
-subnet-prefix-length
-gw
-nas-if-number
-all
target_ipv6_address
nas-if-number
-nas-if-number
This parameter specifies the destination IPv6 address in the route to be deleted.
target_ipv6_address
IP address (IPv6 format)
Example: -ip 2001:db8::/32
Optional. This parameter specifies the subnet prefix length that is to be deleted between 3
and 128.
prefix_length
Subnet prefix length (3 to 128)
This parameter specifies the gateway IP address that is used by the route to be deleted.
However, if the "-all" parameter is specified, the "-gw" parameter is optional.
gateway_address
Gateway IP address (IPv6 format)
Example: -gw fe80::250:56ff:feaa:2c1b
This parameter specifies one NAS interface that is to be used by the route.
• A NAS interface number that does not exist cannot be specified.
• If the specified NAS interface number is assigned to the port that configures the multipath,
both CMs must be set with the same route.
If the route on both CMs are set differently, the route information is not set correctly when a
line failure occurs and the CM communications path is switched.
nas-if-number
NAS interface number
This parameter deletes all routes that can be deleted.
-all All routes
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
[-subnet-prefix-length prefix_length
} | -all}
788
]
P2X0-1210-05ENZ0