Table of Contents
Advertisement
3.WIRING
2) Connection
Insert the core of the cable into the opening and tighten the screw with a flat-blade
screwdriver so that the cable does not come off. (Tightening torque: 0.5 to 0.6N
Before inserting the cable into the opening, make sure that the screw of the terminal
is fully loose.
When using a cable of 1.5mm2 or less, two cables may be inserted into one opening.
• Tip thickness 0.4 to 0.6mm
• Overall width 2.5 to 3.5mm
To loosen.
To tighten.
Control circuit terminal block
3– 5
Flat-blade screwdriver
Cable
Opening
m)
•
3
Advertisement
Table of Contents
