Mitsubishi Electric MELSERVO MR-J2-A Product Specifications And Installation Manual page 70

2. OPERATION
Class No. Symbol
18 *DMD Status display selection:
Used to select the status display shown at power-on.
0
Name and Function
0
Selection of status display at
power-on
0: Cumulative feedback pulses
1: Servo motor speed
2: Droop pulses
3: Cumulative command pulses
4: Command pulse frequency
5: Analog speed command voltage
(Note 1)
6: Analog torque command voltage
(Note 2)
7: Regenerative load ratio
8: Effective load ratio
9: Peak load ratio
A: Within one-revolution position
B: ABS counter
C: Load inertia moment ratio
Note: 1. In speed control mode. Analog
speed limit voltage in torque
control mode.
2. In torque control mode. Analog
torque limit voltage in speed or
position control mode.
Status display at power-on in
corresponding control mode
0: Depends on the control mode.
Control
Mode
Position
Position/speed Cumulative feedback pulses/servo motor speed
Speed
Speed/torque Servo motor speed/analog torque command voltage
Torque
Torque/position Analog torque command voltage/cumulative feedback pulses
1: Depends on the first digit setting of this parameter.
2– 39
Initial
Unit
Value
0000
Status Display at Power-On
Cumulative feedback pulses
Servo motor speed
Analog torque command voltage
Setting
Control
Range
Mode
0000h P • S • T
to
001Ch
2