Huawei FusionModule500 User Manual page 93

FusionModule500 Smart Mini Data Center
User Manual (ECC800e)
Figure 2-81 Loosening the captive screws on the circuit breaker panel
Step 2 Install cables for batteries with different configurations as follows.
1.
2.
3.
4.
5.
6.
Step 3 Connect the batteries to a circuit breaker, as shown in
Issue 07 (2019-12-20)
Place batteries at the bottom layer of the battery cabinet based on battery configurations.
Connect cables between batteries at the bottom layer, after connecting each battery
terminal, cover the terminal with an insulation cap.
Repeat the preceding steps to install cables for batteries in other layers
Connect cables to circuit breakers first and then to battery strings.
Connect batteries in different layers.
Check that the cable connection battery strings meet requirements and the voltage is
equal or greater than 250 V. Then switch the power circuit breaker to OFF and connect
batteries and UPSs correctly.
Copyright © Huawei Technologies Co., Ltd.
Figure 2-82.
2 Installation
84