Huawei FusionModule500 User Manual page 38

FusionModule500 Smart Mini Data Center
User Manual (ECC800e)

Do not remove anchor bolts. Otherwise, you need to rework them for use.

You can use a wrench, socket, or screwdriver to adjust anchor bolts. Rotate anchor bolts
clockwise to raise the cabinet and rotate them counterclockwise to lower the cabinet.
Anchor bolts can be adjusted within a range of 0–8 mm.

Levelness check standard: Ensure that the cabinet is level in width and depth directions
when leveling the cabinet. Put a level at the bottom of the cabinet in width and depth
directions and check that the air bubble is in the middle between the two lines marked on
the glass tube.
Figure 2-7 Leveling a cabinet
(1) Level
1.
2.
3.
Step 5 Block the holes that are used to secure the cabinet to the floor using rubber plugs.
Issue 07 (2019-12-20)
Measure the distance between the floor and the top of the cabinet using a measuring tape.
Then adjust the cabinet height to 2000–2003 mm by rotating anchor bolts.
(Optional) If the left and right rear doors of the cabinet have different heights, slightly
adjust the two anchor bolts on the side of the lower door to restrict the height difference
within 3 mm.
Measure the cabinet using a level and slightly adjust the anchor bolts until the cabinet is
level.
Copyright © Huawei Technologies Co., Ltd.
2 Installation
29