ABB IRB 7600 Series Product Manual page 124

2 Installation and commissioning
2.6.5 Installation of position switches (option)
Continued
9
10
11
12
124
Action
Connect the connector R3.FAN3 to the fan
of axis 3. If no fan is used, strap the cable
together with the robot cabling.
Connect the connector R1.SW2/3 to the
base of the robot. Make sure that the
cabling, run through the base, frame and
lower arm, is not twisted and is running free
from the robot cabling.
Refit the rear cover to the robot base.
Install additional cabling to and inside the
control cabinet.
© Copyright 2007 - 2018 ABB. All rights reserved.
Note
xx0500002314
Cabling is specified in section:
• Position switch cables, robot base
to controller (option) on page 127
Product manual - IRB 7600
3HAC022033-001 Revision: V