Procedure For Commissioning The Base Station That Starts To Provide Services Of One; Mode - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
3
Procedure for Commissioning the Base
Station that Starts to Provide Services of One
This section describes the procedure for commissioning the base station that starts to provide
services of one mode.
Prerequisites
Before commissioning the MBTS, the MBTS, MBSC, and M2000 must meet following
requirements:
l
l
l
Commissioning Procedure Without Co-transmission
Assume that the MBTS supports mode A and mode B, that co-transmission is unavailable to the
two modes, and that services of only mode A starts to be provided.
l
Issue 02 (2010-07-30)
The MBTS hardware such as the cabinets, cables, antenna system, and auxiliary devices,
is installed and passes the installation check. In addition, check that the MBTS is powered
on and passes the power-on check.
The hardware of the MBSC is installed and commissioned, and the system works properly.
The negotiation data of the MBTS to be commissioned is configured and recorded.
The M2000 server is installed with an adaptation layer whose version matches the version
of the MBTS to be commissioned.
NOTE
The alarm Inter-System Communication Failure may be reported when the base station in mode A is
commissioned, and the alarm RRU Network Topology Type and Configuration Mismatch， Inter-
System Control Rights Conflict may be reported in a dual-mode scenario. These alarms do not affect the
commissioning and services, and therefore you can shield them manually.
The MBTS works in GU or GL mode and GSM services are provided at first. Or, the
MBTS works in UL mode and services of one mode are provided at first.
Figure 3-1 shows the commissioning procedure.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Procedure for Commissioning the Base Station that Starts
to Provide Services of One Mode

Mode

3-1