Commissioning The Mbts By Using Usb And M2000 - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
6
Commissioning the MBTS by Using USB
About This Chapter
This chapter describes how to upgrade software and configure data using a USB disk, check the
operating status of the MBTS hardware, and rectify the MBTS hardware faults (if any) in time
at the MBTS. This section also describes how to check the operating status of the MBTS on the
M2000.
6.1 Procedure for Commissioning the MBTS by Using USB and M2000
At the local end of the MBTS, you can use a USB disk to upgrade the MBTS software and data,
and check whether the MBTS hardware status is normal according to the board status and LED
status, to locate and rectify faults in time. At the remote end of the MBTS, you can perform fault
diagnosis on the MBTS and verify services of the MBTS on the M2000.
6.2 Preparing the USB Disk for Local Commissioning
The USB disk should be ready before it is used for local commissioning. The preparation of the
USB disk for local commissioning varies according to the base station mode. Therefore, you
must prepare the USB disk based on the mode of the base station to be commissioned.
6.3 Upgrading Software and Configuring Data by Using the USB Disk
You can locally upgrade software and configure data of a base station by using the USB disk on
the base station side.
6.4 Checking the Status of the LEDs and Rectifying the Faults
This section describes how to check the operating status of the LEDs according to the states of
the LEDs on the modules of the base station.
6.5 Set the Download Control Right
If the BTS is working in the co-module scenario, the download control right needs to be set. The
system with the download control right upgrades the co-modulated RRU3908/MRFU and the
USCU software during software upgrade.
Issue 02 (2010-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

6 Commissioning the MBTS by Using USB and M2000

and M2000
6-1