Upgrading The Enodeb Software And Downloading The Data Configuration File (On The Enodeb Side) - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
The NodeB resets.
The NodeB runs
normally.
----End
6.3.3 Upgrading the eNodeB Software and Downloading the Data
Configuration File (on the eNodeB Side)
This section describes how to download and activate the eNodeB software and data configuration
file through the USB storage device. The eNodeB automatically downloads the software and
data configuration file from the USB storage device, and then activates them. The software and
data configuration take effect after the eNodeB resets.
Prerequisite
The USB storage device is ready for use. The required files are saved in the USB storage device.
For details, see
If one USB storage device is used repeatedly, the target eNodeB software and data configuration
file in the USB storage device should be updated before the USB storage device is used for an
eNodeB deployment.
When you save the eNodeB software and data configuration file to the USB storage device,
ensure that the locking switch on the USB storage device is disabled. In other words, the USB
storage device should be writable.
Context
When the LMPT of the BBU3900 is started, it automatically detects the USB storage device,
reads the related software and data configuration file in the USB storage device, and verifies the
file names and formats.
If you install the BBU before installing the RRU, you can install and power on the RRU during
the process of BBU software downloading. After the BBU software is downloaded and activated
Issue 02 (2010-07-30)
Status of the LED
on the USB Disk
ON first, OFF for a
while, and then
blinking
ON
NOTE
The time for downloading software and data configuration file from the USB disk and the time for the
NodeB to activate the software may differ from those in
configuration.
6.2.3 Arranging the USB Disk for Local eNodeB
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the MBTS by Using USB and M2000
State of the RUN
LED on the
WMPT
ON first, OFF for a
while, and then
blinking (ON for
0.125s and OFF for
0.125s)
Blinking (on for 1s
and off for 1s)
Table 6-5, according to the version and
Duration
About 2 minutes
-
Commissioning.
6-17