Connecting The Smt Client And The Base Station - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
Step 5 Select Use the following IP address.
Step 6 Enter the correct IP address, subnet mask, and default gateway. Ensure that the IP address of the
SMT client is on the same network segment as the IP address (192.168.0.72/255.255.255.0) of
the base station, so that a local OM channel can be established.
Step 7 Click OK to complete the settings.
----End

7.2.2 Connecting the SMT Client and the Base Station

This section describes how to connect the SMT client to the ETH port on the GTMU of the base
station through an Ethernet cable. After the connection is established, you can operate and
maintain the base station on the SMT.
Prerequisite
The IP address and subnet mask of the SMT client are set correctly. The IP address of the SMT
client is on the same network segment as the IP address (192.168.0.72/255.255.255.0) of the
base station.
Procedure
Step 1 Use an Ethernet cable to connect the SMT client and the base station. One end is connected to
the ETH port on the GTMU of the main cabinet, and the other end is connected to the Ethernet
port on the SMT client (generally a laptop).
Step 2 Open an MS-DOS command prompt window.
l
Step 3 Run ping 192.168.0.72 to verify the network connection between the SMT client and the base
station.
192.168.0.15 is the IP address of the base station.
l
l
Issue 02 (2010-07-30)
In the case of the Windows 2000/XP operating system, choose Start > Run at the lower-left
corner of the computer's desktop. In the Run dialog box, enter cmd and click "OK". The
MS-DOS command prompt window is displayed.
NOTE
If the information similar to that in the following example is returned, you can infer that the
SMT client and the BBU can communicate normally.
Pinging 192.168.0.72 with 32 bytes of data:
Reply from 192.168.0.72: bytes=32 time=1ms TTL=253
Reply from 192.168.0.72: bytes=32 time=1ms TTL=253
Reply from 192.168.0.72: bytes=32 time=1ms TTL=253
Reply from 192.168.0.72: bytes=32 time=1ms TTL=253
Ping statistics for 192.168.0.72:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms
If the SMT client and the BBU cannot communicate properly, the possible causes are as
follows:
The GTMU is faulty.
–
The Ethernet cable is disconnected or in poor contact.
–
The COM port of the SMT client is faulty.
–
The base station is resetting.
–
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Commissioning the MBTS by Using Local Maintenance
Terminal and M2000
7-7