Huawei 3900 Series Commissioning Manual page 122

6 Commissioning the MBTS by Using USB and M2000
Procedure
l
l
6-4
NOTE
The priority of a mode does not need to be considered during the MBTS commissioning.
l
When a base station supporting two modes is deployed,
l
The two modes must be upgraded separately if only one USB disk is available for the upgrade on
l
site.
The two modes can be upgraded simultaneously by inserting the two USB disks into the USB ports
l
on the main control boards in the two modes if two USB disks are available for the upgrade on site.
If the MBTS that works in the co-module scenario is not connected with Base Station Controler, to
l
upgrade with a USB disk locally will raise the Inter-System Control Rights Conflict alarm. This
alarm will not affect the commissioning and the services. After the BTS connects with Base Station
Controler, manually sets the download control right, which will clear this alarm.
Local end of the MBTS
1. Insert the USB disk into the USB port on the panel of the main control board in specific
mode. Choose an appropriate operation based on the active software version and data
configuration of the MBTS.
If...
The active software version and data
configuration are inconsistent with
those in the USB disk,
The active software version and data
configuration are consistent with those
in the USB disk,
2. The base station automatically upgrades the software and data. For details, see
Upgrading Software and Configuring Data by Using the USB
3. Check whether the MBTS hardware is normal according to the LED status. For details,
see 6.4 Checking the Status of the LEDs and Rectifying the
4. Remove the USB disk before leaving the site.
Remote end of the MBTS
NOTE
When the MBTS is commissioned remotely on the M2000, commission the base station of a mode,
and then commission the base station of the other mode. The two modes are equal in priority.
1. Wait till the transmission is available.
2. Optional: If the MBTS is working in the co-module scenario, the download control
right needs to be set. During the commissioning on the M2000, the M2000
automatically compares the software version of the system with the download control
right to the software version of the current co-module MRFU/RRU3908, and check
their consistency. If the versions are not consistent, the MBTS automatically upgrade
the MRFU/RRU3908. For detail of setting the download control right, see
Download Control
3. Create a commissioning task on the M2000. For details, see
Commissioning
4. Optional: If a GBTS is to be commissioned and Intervening transmission is selected
when a commissioning task is created, manually check the GBTS transmission state
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Right.
Task.
3900 Series Multi-Mode Base Station
Commissioning Guide
Then...
Go to step Step 2.
Remove the USB disk, because the
software and data of the base station in
the specific mode have been upgraded.
Disk.
Faults.
5.2 Creating a
Issue 02 (2010-07-30)
6.3
6.5 Set the