Connecting The Lmt Client And The Base Station; Table 7-2 Ip Parameters Of The Lmt Client For Commissioning On The Nodeb Side; Table 7-3 Parameters For Setting The Route From The Pc To The Gateway - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide

Table 7-2 IP parameters of the LMT client for commissioning on the NodeB side

Parameter
IP Address
Subnet Mask
Default Gateway
The IP addresses on the same network segment correspond to the same subnet masks and subnet addresses
(subnet mask AND IP address).
Step 9 Click OK to complete the settings.
----End

7.5.2 Connecting the LMT Client and the Base Station

This section describes how to set the route from the LMT client to the NodeB in remote
maintenance mode. If you do not set the route in remote maintenance mode, you fail to log in
to the NodeB through the LMT client.
Procedure
Step 1 On the LMT client, choose Start > Run, and then run the cmd command. The command window
is displayed.
Step 2 Run the ROUTE ADD Networkaddress MASK netmask gatewayaddress command in the
command window to add a route from the PC to the gateway. Then, set "Networkaddress",
"netmask", and "gatewayaddress". For details, see

Table 7-3 Parameters for setting the route from the PC to the gateway

Parameter
Networkaddress
netmask
gatewayaddress
Issue 02 (2010-07-30)
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Commissioning the MBTS by Using Local Maintenance
Description
The IP address of the LMT client is on the same network segment
as the IP address of the NodeB local maintenance channel.
In local maintenance mode, the IP address of the NodeB is
17.21.2.15 by default.
The subnet mask of the LMT client is the same as that of the NodeB
local maintenance channel.
Table
Description
OM IP address of the NodeB.
Subnet mask of the PC is the same as the
external subnet mask of the RNC BAM.
External IP address of the BAM.
Terminal and M2000
7-3.
7-33