6 Commissioning the MBTS by Using USB and M2000
Procedure
Step 1 Plug the USB disk into the USB port on the WMPT of the BBU3900, as shown in
Figure 6-3 Plugging the USB disk into the USB port on the WMPT
Step 2 The NodeB automatically downloads the software and data configuration file, and activates the
software. After the activation, the NodeB resets. Wait until the NodeB reset is complete. For
details on the status of the LED on the USB disk and the status of the RUN LED on the WMPT
in this process, see
Table 6-5 LEDs on the USB disk and the WMPT
When the USB disk is
plugged into the
corresponding port on
the WMPT, the
WMPT automatically
detects the USB disk.
The WMPT
downloads the
software and data
configuration file
from the USB disk.
The WMPT activates
the software.
6-16
The software version to be used is the same as the active software version.
–
The data to be used in the configuration file is the same as the active configuration data.
–
Table
6-5.
Status of the LED
on the USB Disk
ON
Blinking
ON
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3900 Series Multi-Mode Base Station
State of the RUN
LED on the
WMPT
Blinking (on for 1s
and off for 1s)
Blinking (ON for
0.125s and OFF for
0.125s)
Blinking (ON for
0.125s and OFF for
0.125s)
Commissioning Guide
Figure
6-3.
Duration
About 1s to 2s
About 12 minutes
About 3 to 4 minutes
Issue 02 (2010-07-30)